2.2 KiB
Goals
cabletest finds Ethernet cables that misbehave under sustained full-duplex 10 Gbit load. It exchanges raw Ethernet frames (no IP, no ARP) across a variety of sizes and payloads between two directly-cabled ports on one host, and attributes every problem it can to the cable rather than the host. It runs as PID 1 on a dedicated appliance with a framebuffer UI; development happens on the same machine under Arch.
The target of measurement is the cable, not throughput. Line rate is a means to stress the physical layer. The outputs that matter, roughly in order:
- Loss and error attribution — reception gaps, link errors, NIC/driver counters as first-class output alongside application loss. Baseline loss must be exactly zero before a run counts; any host-side loss masks real cable faults.
- Noise tolerance — a deliberately-bad "noise" cable intertwined with the test cable, driven by link up/down cycling, stresses the cable under test with alien crosstalk.
- Per-pair SNR from the module PHYs — the leading indicator of a marginal cable before it drops frames. IEEE 802.3an standard registers on the Marvells; the BCM leaves those unpopulated and reports through its vendor command handler instead (transports.md).
- Cable length — sanity check and fault localization. Sources, in preference order:
- Module PHY DSP estimate — works on a linked cable.
- PHY TDR — localizes opens/shorts both-ended; healthy-cable length only single-ended.
- NIC timestamp path-delay — works linked, module-independent; needs per-packet or PTP-latch hardware timestamps and a short-cable calibration.
- Pre-FEC error visibility — corrected-error counters that move before post-FEC loss appears. Vendor-specific; still unlocated on the module PHYs we can talk to. Standard latched PCS counters (errored blocks, BER, block-lock loss) are the working proxy under noise stress.
Design preferences that shaped the tool: plain sockets first, escalate only after measuring (AF_PACKET reached line rate on the shipping mix; the AF_XDP experiment is parked); pre-populated frame contents; goroutine-heavy is fine (many cores to burn); DPDK is off the table — it would kill the sysfs counters and link management the tester depends on.