 flamingcow
|
e99c7121e7
|
Bridged MDIO reads verify freshness: a late async fetch serves the previous response as the wrong register (observed STATUS 0x0004 as 0.4dB SNR); unchanged-or-zero results re-read bare without re-arming until stable, first read always verified, identify retries against the constant PHY ID
|
2026-08-13 08:26:22 -07:00 |
|
|
flamingcow
|
bba1fa5e02
|
Jumbo in the size mix (MTU 9000 + module jumbo pinned), check-first module config trusting GET reads, cable diag async at startup through the reset path, MODULES table dissolved into SETTINGS/LINKS, per-driver NIC counter sets, comment cleanup
|
2026-08-13 08:04:26 -07:00 |
|
|
flamingcow
|
979dc7a772
|
BCM module diagnostics replace timestamp probes: bringup forces EEE off and runs ECD (re-run on every reset, re-baselining past its blip), 1 Hz SNR margin + corrected counters on panel and console; X520 bench divergences bypassed and tracked in open-questions
|
2026-08-13 07:10:39 -07:00 |
|
|
flamingcow
|
a00f2216b7
|
BCM bridge tolerates MCIA offset-write-then-read framing, proven on hardware via bcm_mcia_emu.py; MCIA question narrows to firmware acceptance of 0x56 and offset/framing details
|
2026-08-12 21:39:46 -07:00 |
|
|
flamingcow
|
65b1e18004
|
Dissolve resolved analyses into standalone device docs; open-questions.md keeps only the four live problems; discard NIC-timestamp length path (BCM ECD is proven) and Aquantia length trivia (30m part, oracle-only)
|
2026-08-12 21:30:16 -07:00 |
|
|
flamingcow
|
5588ebec6f
|
Resolve X520 open questions on hardware: ETQF raw-L2 steering and single-hold compound I2C proven; 82599 has no all-packet exact-timestamp path so it is disqualified as product NIC (diagnostics-only), counter route rejected for a cable tester
|
2026-08-12 20:36:31 -07:00 |
|
|
flamingcow
|
ad9bc9fae4
|
BCM ECD recovered from OpenBCM SDK and proven: 1E.4006 start, 1.A896 verdicts, 1.A897-9A per-pair meters -- meter-accurate on a 45m cable, healthy pairs report length
|
2026-08-12 19:37:54 -07:00 |
|
|
flamingcow
|
c57816345f
|
Restructure docs: per-device directories under modules/ and nics/ with co-located datasheets, state centralized in state.md, prose tightened into lists and tables
|
2026-08-12 19:23:02 -07:00 |
|
|
flamingcow
|
01e00dfffe
|
BCM path proven on X520: fix multi-byte i2c read (SDA release), GET_SNR is 0x8030 invoked bare, IEEE SNR regs dead on BCM, module pause forced off
|
2026-08-12 17:50:14 -07:00 |
|
|
flamingcow
|
6f787c0873
|
Record X520 install: FS+Wiitek seated and linked, FS's honest EEPROM is what trips ixgbe qualification, uplink moved to enp88s0
|
2026-08-12 17:35:25 -07:00 |
|
|
flamingcow
|
5f4a8ceb57
|
Vendor AQR datasheet, correct timestamp model (hw rx stamps are a hard requirement), order ConnectX-5, map 82599 bucket-timestamp routes
|
2026-08-10 12:50:57 -07:00 |
|
|
flamingcow
|
73074040e0
|
Answer open questions from desk analysis: ETQF steering, E820 is post-FEC, compound I2C op, forced co-location
|
2026-08-10 11:51:39 -07:00 |
|
|
flamingcow
|
44e010caa9
|
Note Wiitek ixgbe RollBall client and flag ixgbe RX-steering as open investigation
|
2026-08-10 11:29:05 -07:00 |
|
|
flamingcow
|
3f1bb03e52
|
Record X520 ixgbe raw-i2c patch and BCM client prep in state doc
|
2026-08-10 11:21:49 -07:00 |
|
|
flamingcow
|
6597a11c33
|
Add in-repo project docs: goals, state, hardware, module-PHY transports, module diagnostics, and measurement lessons
|
2026-08-10 10:34:26 -07:00 |
|